1. Single-Pilot Toggle Control of a Pneumatic Fixture
A fixture needs successive pneumatic commands to alternate between two directional working states. The valve changes output routing between ports 2 and 4 each time a pilot signal reaches port 14, retaining the selected position between commands. Its 3–8 bar supply requirement and 3 mm barbed connections define the component interface for the pneumatic command and working circuits.
Problem Solved
A single pilot-signal path alternates the two working connections, providing pneumatic toggle behavior for a fixture without requiring two separate directional pilot-command lines.
Single pilot port 14
Alternating outputs 2/4
3–8 bar
2. Alternating Air Supply to Two Process Branches
A machine needs to direct successive air commands to alternating process branches, such as two small clearing nozzles used on alternate steps. Outputs 2 and 4 provide the two working paths, and each new pilot signal changes the selected routing. The 105 l/min P-to-A flow and 2.5 mm orifice characterize the valve component for evaluating those air branches.
Problem Solved
The pulse-actuated shuttle alternates branch selection on successive commands, supplying a pneumatic mechanism for distributing the working supply between two process paths.
Two alternating branches
105 l/min P→A
2.5 mm orifice
3. Every-Other-Event Pneumatic Sequence Signal
A pneumatic sequence needs an alternating state from a repeated stream of pilot events. Because the selected output changes on every input pulse, a given output returns to its previous routing state after two events. The valve specifies a 10 ms minimum signal period and a 20 ms response at 6 bar, providing component timing characteristics for evaluating the sequence.
Problem Solved
The binary switching mechanism converts repeated pilot events into alternating pneumatic states, allowing a downstream circuit to distinguish successive events in an every-other-event sequence.
Binary alternating state
10 ms minimum signal period
20 ms at 6 bar