Omron Pressure Sensors / Flow Sensors

Omron E8F2 Series – Digital Pressure Sensor- Pressure Sensors / Flow Sensors

USD $ 100.80 – USD $ 365.40

SKU: N/A

Omron produce industrial sensors range such as fiber sensors, photoelectric sensors, displacement sensors/ measurement sensors, proximity sensors, photomicro sensors and rotary encodes.

Features

• Pressure status can be checked at a glance from the digital display and bar display.

• Measurement pressure prevents incorrect outputs due to momentary pressure changes. (*)

• Perform automatic teaching simply by teaching pressure values for good and bad products.

• Compact models at just 28 × 28 × 29 mm.

 

* Only in hysteresis mode.

 

Lineup

Sensors

Pressure range ON/OFF output Linear output Model
NPN output PNP output
Positive pressure 0 to 100 kPa Open collector
(two independent outputs)		 1 to 5 V E8F2-A01C E8F2-A01B
0 to 1 MPa E8F2-B10C E8F2-B10B
Negative pressure 0 to -101 kPa E8F2-AN0C E8F2-AN0B

Accessories (Order Separately)

Appearance Name Model Remarks
Mounting Bracket E89-F3 Provided with the E8F2.
Panel-mounting Bracket E89-F4 Spacer provided.

 

Specifications

Sensor

Model NPN output E8F2-A01C E8F2-B10C E8F2-AN0C
PNP output E8F2-A01B E8F2-B10B E8F2-AN0B
Power supply voltage 12 to 24 VDC±10% with a ripple (p-p) of 10% max.
Current consumption 70 mA max. * 1
Pressure type Gauge pressure
Rated pressure range 0 to 100 kPa 0 to 1 MPa 0 to -101 kPa
Pressure setting range 0 to 100 kPa 0 to 1 MPa 0 to -101 kPa
Withstand pressure 400 kPa 1.5 MPa 400 kPa
Applicable fluid Non-corrosive gas and non-flammable gas
Operating mode Hysteresis mode, window mode, and automatic teaching mode
Repeat accuracy
(ON/OFF output)		 ±1%FS max.
Linearity (linear output) ±1%FS max.
Response time
(ON/OFF output)		 5 ms max.
Linear output 1 to 5 V ±5% F.S. with an output impedance of 1 kΩ and a permissible resistive load of 500 kΩ.
ON/OFF outputs NO or NC open collector (depending on whether the output configuration is NPN or PNP)
ON/OFF
outputs		 Load current 30 mA max.
Output applied voltage 30 VDC max.
Residual voltage NPN open collector output: 1 V max. with 30 mA load current
PNP open collector output: 2 V max. with 30 mA load current
Display * 2 3.5-digit red LED
Green LED bar indicator
The orange LED is lit for two independent outputs with output transistor turned ON.
Green unit indicator
Display accuracy ±3%FS±1 digit max.
Protection circuits Reverse polarity protection, load short-circuit protection
Ambient temperature range Operating: 0 to 55°C
Storage: – 10 to 60°C (with no icing)
Ambient humidity range Operating/Storage: 35% to 85% (with no condensation)
Temperature influence ±3%FS max.
Voltage influence ±1.5%FS max.
Insulation resistance 100 MΩ min. (at 500 VDC) between current-carrying parts and case
Dielectric strength 1,000 VAC at 1 min
Vibration resistance Destruction: 10 to 500 Hz, 1.0-mm double amplitude or 150 m/s2, three times each for 11 min in the X, Y, and Z directions
Shock resistance Destruction: 300 m/s2 3 times each in the X, Y, and Z directions
Degree of protection IP50 (IEC)
Pressure port R (PT) 1/8 taper screw and M5 female screw
Connection method Pre-wired (standard length: 2 m)
Cable Approved by UL
Weight (packed state) Approx. 110 g
Material Pressure port Aluminum die-cast
Case Heat-resistive ABS
Accessories Mounting Bracket, Instruction manual

*1. The current consumption is approximately 43 mA in energy-saving mode.
*2. Display Example of Digital Indicator

 

Model Setting unit
kPa
Applied pressure Digital display
E8F2-A01C 100
E8F2-B10C 1000
E8F2-AN0C -101
Note: The period ( ) in the display indicates the decimal point.
Its position will not change unless the setting unit is changed.

Related products