The StarterFirmware class provides methods for updating the starter firmware of a connected camera. This is also possible from within the IDS Camera Manager. You can also read out the estimated time it will take the uEye driver to execute specific processes (e.g. update the camera firmware).
|
This class is only supported by the cameras of the GigE uEye series. GigE uEye RE series cameras use the same firmware as GigE uEye SE series cameras. For GigE uEye RE cameras please use the GigE uEye SE method. |
|
The starter firmware determines the start-up behaviour of the GigE uEye camera. We recommend that you do not update the starter firmware unless an older firmware version causes start-up problems. If you have questions on the current starter firmware, please contact the Machine Vision Consulting. |
Methods
Method |
Description |
|---|---|
Returns the estimated time for uploading the starter firmware to a GigE uEye cameras. This is a generic parameter which does not require you to specify the camera type. |
|
Returns the estimated time for uploading the starter firmware to a GigE uEye CP camera. |
|
Returns the estimated time for uploading the starter firmware to a GigE uEye SE/RE camera. |
