The Software class provides methods for controlling the automatic image control features.
•Control is only active as long as the camera is capturing images.
•A manual change of the exposure time and gain settings disables the auto functions.
•When the auto exposure shutter function is enabled, you cannot modify the pixel clock frequency.
•The auto frame rate function is only available when the auto shutter control is on. Auto frame rate and auto gain control cannot be used simultaneously.
•The auto gain function can only be used for cameras with master gain control. Auto white balance is only available for cameras with hardware RGB gain control.
|
Notes on the sensor's internal control functionality Automatic control by the sensor and the software is not possible simultaneously. To use the sensor's internal control functionality, disable software control, and vice versa. |
|
Note on automatic controls when using very high frame rates Using very high frame rates can cause that too many control commands are sent to the camera. When using frame rates higher than 100 fps you should increase the value for the skipped frames via Set(). Thus, less image will be used for the automatic controls which takes load off the camera. |
The following classes exist:
