This chapter contains the descriptions of all supported features from the User Set Control category.
Name |
UserSetControl |
Category |
Root |
Interface |
Category |
Access |
Read |
Unit |
- |
Visibility |
Beginner |
Values |
- |
Standard |
SFNC |
Availability uEye+ |
|
Availability uEye |
|
It describes the features for global control of the camera settings. The features allow loading and saving factory settings as well as user-defined settings.
•Predefined user sets allow to switch between different operation modes like "Linescan" or "LongExposure".
•UserSetDefault specifies which user set you want to load and enable by default after a camera reset.
•The UserSetSelector defines the user set you want to load with UserSetLoad, save with UserSetSave or use as default.
|
The following camera settings are not saved in the user sets: •Any settings from the GigEVision category. •Any settings from the LUTControl category. |
|
User-defined user sets (UserSet0 and UserSet1) are not imported in the case of a firmware update. If you use user-defined user sets, make sure that you can set up them again after the firmware update. |
For more information about how to load and save camera settings, see Saving and loading camera settings (UserSets).
