Effective height of the sensor in pixels.
Name |
SensorHeight |
Category |
|
Interface |
Integer |
Access |
Read (/Write, see USB3 cameras with SensorOperationMode "Linescan") |
Unit |
px |
Visibility |
Expert |
Values |
Camera specific |
Standard |
SFNC |
Availability uEye+ |
|
Availability uEye |
|
USB3 cameras with SensorOperationMode "Linescan"
From firmware 3.20 on, you can set an individual line height for the following USB3 cameras in SensorOperationMode "Linescan".
Camera type |
Minimum |
Maximum |
Increment |
Default value |
|---|---|---|---|---|
Color camera |
2 |
Sensor height |
2 |
2 |
Monochrome camera |
1 |
Sensor height |
1 |
1 |
If you set SensorHeight to a value > Height, Height will be set to the same value as SensorHeight. The value of Height can only be a multiple of the value of SensorHeight.
This function can be used with the following models:
•U3-300x color / mono
•U3-304x color / mono
•U3-306x color / mono
•U3-307x color / mono
•U3-308x color / mono
•U3-309x color / mono
•U3-30Cx color / mono
•U3-31Fx color / mono
•U3-31Jx color / mono
•U3-31Lx color / mono
•U3-320x color / mono
•U3-326x color / mono
•U3-327x color / mono
•U3-328x color / mono
•U3-329x color / mono
Code example
C++
// Determine the current SensorHeight
int64_t value = nodeMapRemoteDevice->FindNode<peak::core::nodes::IntegerNode>("SensorHeight")->Value();
C#
// Determine the current SensorHeight
long value = nodeMapRemoteDevice.FindNode<peak.core.nodes.IntegerNode>("SensorHeight").Value();
Python
# Determine the current SensorHeight (int)
value = nodeMapRemoteDevice.FindNode("SensorHeight").Value()
