USD 241.33
Omron E3NX-CA41 2M is a PNP color fiber amplifier with 1 output, 10–30 VDC and response modes from 50 μs (contrast mode) to 16 ms.
The Omron E3NX-CA41 2M is a pre-wired color fiber amplifier with PNP output and 1 output. It uses white led, 420–700 nm, operates from 10–30 VDC, and supports response modes SHS: 50 μs in contrast mode; HS: 250 μs; standard: 1 ms; GIGA: 16 ms; smart tuning and dynamic power control are available. The amplifier accepts compatible E32 fiber units, sold separately. Current supply status is not established by consulted manufacturer material and is recorded as Unknown.
A PNP color fiber amplifier for use with a compatible Omron fiber unit.
| Parameter | Value |
|---|---|
| Product type | color fiber amplifier unit; fiber unit sold separately |
| Model / output | E3NX-CA41 PNP |
| Inputs / outputs | 1 output |
| Light source | White LED, 420–700 nm |
| Power supply | 10–30 VDC; ripple 10% p-p max. |
| Power consumption | Normal mode: 960 mW max. (40 mA max.) at 24 VDC; Eco ON 720 mW max.; Eco LO 800 mW max. |
| Control output | PNP open collector; 30 VDC max.; 100 mA max. (1–3 amplifiers) or 20 mA max. (4–30); residual 1 V max. below 10 mA or 2 V max. at 10–100 mA |
| Response time modes | SHS: 50 μs in contrast mode; HS: 250 μs; standard: 1 ms; GIGA: 16 ms |
| Sensitivity adjustment | Smart Tuning and manual adjustment |
| Key functions | APC, DPC, timer, eco modes and bank switching |
| Ambient temperature | Group-dependent operation from −25 to +55 °C; storage −30 to +70 °C; no icing or condensation |
| Ambient humidity | Operating/storage 35–85% RH; no condensation |
| Connection | Pre-wired cable, 2 m |
| Housing material | Polycarbonate (PC) case and cover; PVC cable |
| Physical Weight (kg) | Approx. 0.115 kg packed / 0.075 kg sensor only |
| Dimensions L x W x H (cm) | See Omron dimension drawing; numeric dimensions not transcribed |
| Supply status | Unknown; current manufacturer supply state not established |
Engineering suggestions require suitability checks for your installation.
A production station may require a fiber-based detection point with response adjusted to line speed.
Select a response mode appropriate to the required stability and timing, pair with a compatible E32 fiber unit, and validate the full detection cycle on the machine.
A line may need to distinguish a workpiece condition at a small or hard-to-access sensing point.
For CA models, register and evaluate the target in contrast or RGB-ratio color mode; for FA models, tune sensitivity against the actual target and background. Verify output wiring before operation.
