|
NOTICE! The General Purpose I/Os are not potential-free and have no protective circuit. Faulty wiring (overvoltage, undervoltage) can result in a damage in the electronics. |
8-pin Hirose connector (HR25-7TR-8PA(73))
Pin |
Description |
 Fig. 364: Hirose connector male, camera rear view |
|---|---|---|
1 |
Ground (GND) |
|
2 |
Flash output with optocoupler (-) |
|
3 |
General Purpose I/O (GPIO) 1, 3.3 V |
|
4 |
Trigger input with optocoupler (-) |
|
5 |
Flash output with optocoupler (+) |
|
6 |
General Purpose I/O (GPIO) 2, 3.3 V |
|
7 |
Trigger input with optocoupler (+) |
|
8 |
Voltage output •Without USB Power Delivery: 5 V, max. 100 mA •With USB Power Delivery: 5 – 15 V, max. 1 A |
The color assignment of the used I/O cable is specified in the data sheet of the cable. For I/O cables from IDS Imaging Development Systems GmbH, you can find the data sheet on the website. Select the specific I/O cable in the download area and view the associated data sheet.
 |
The maximum length of the I/O cable is 30 m. The cable must be shielded. |
Power supply
The camera is supplied with power via the USB 3.0 interface. For information on the camera's power consumption, please refer to the Camera and sensor data section.
Note on Power Delivery
There are only the voltages available on the camera that are offered by the host PC. If you switch from a higher voltage to a lower voltage during operation, the camera will do a reconnect.
