The temperature values given below refer to the outer device temperature of the camera housing. The temperature inside of the camera housing is generally higher than the outer temperature and may be up to 70 °C (158 °F).
The internal temperature of some camera models can be queried.
GigE uEye SE |
|
|---|---|
Device temperature during operation |
0 °C … 55 °C 32 °F … 131 °F |
Device temperature during storage |
-20 °C … 60 °C -4 °F … 140 °F |
Humidity |
20 % … 80 %, relative, non-condensing |
Non-condensing means that the relative air humidity must be below 100 %. Otherwise, moisture will form on the camera surface. If, for example, air has a relative humidity of 40 % at 35 °C (95 °F), the relative humidity will increase to over 100 % if the air cools down to 19.5 °C (67 °F); condensation begins to form.
 |
CAUTION! As the camera housing may get hot depending on the operating conditions there may be risk of burns. Provide sufficient heat dissipation so that the housing temperature does not exceed 55 °C (131 °F). |
Notes on ambient conditions
•Avoid high air humidity levels and rapid temperature changes when using IDS cameras.
•Temperatures below +4 °C (39 °F) combined with excessive relative air humidity levels can cause icing.
•Note that with increasing device temperatures, the image quality may decrease due to thermal noise, even if the camera is operated below the maximum specified temperature.
Provide sufficient heat dissipation to keep temperatures within the specified ranges. The exact temperature conditions depend on the mounting situation. In general, the following recommendations apply:
•Use a thermally-conductive surface, like a metal plate or a heat sink, for a passive heat dissipation.
•If necessary, provide an active cooling for example by means of a fan.
Vibration and shock resistance
Vibration and shock resistance of the cameras were tested as specified in EN 60068-2-6 and EN 60068-2-27.
Test parameter EN 60068-2-6 "Environmental testing - Tests: Vibration" |
|---|
•Vibration mode: Sinus •Lower frequency: 30 Hz •Upper frequency: 500 Hz •Acceleration: 10 g •Throughput speed: 1 octave/minute, logarithmic •Number of frequency cycles: 10 per axis |
Test parameter EN 60068-2-27 "Environmental testing - Tests: Shock" |
|
|---|---|
•Shock form: half sine •Pulse duration: 1,9 ms •Peak acceleration: 80 g •Number of shocks per direction: 3 (± X, ±Y, ±Z) |
•Shock form: half sine •Pulse duration: 6 ms •Peak acceleration: 25 g •Number of shocks per direction: 100 (± X, ±Y, ±Z) |
