IDS peak 2.15.0 / uEye+ firmware 3.54

The UART functionality is only available for cameras that support UART communication on the hardware. This feature is only supported by the following uEye+ cameras.

•USB 3 uEye+ XCP Rev. 1.2

•USB 3 uEye+ XLE Rev. 1.2

•USB 3 uEye+ XLS Rev. 1.2

The hardware must be Rev. 1.2 (or higher), as UART support is included from this hardware on. The description of the GPIO (General Purpose I/O) can be found in the camera manual of the respective camera family.

Buffer with the data received on the UART Rx line. You specify the length of the data to be received in UartRxPacketLength.