|
This function is supported by the following models: U3 models •PCB version uEye+ LE USB 3.1 Rev. 1.2 (requires USB3 Vision firmware 3.2 or higher) •uEye+ LE USB 3.1 Rev. 1.2 AF (requires USB3 Vision firmware 3.2 or higher) •USB 3 uEye+ ACP GV models •GigE uEye+ ACP UI models •PCB version uEye LE USB 3.1 Gen 1 •PCB version USB 3 uEye LE •PCB version USB uEye LE •GigE uEye LE |
Controls the address of the I2C device. All addresses from minimum to maximum of the register node are allowed.
Name |
I2CDeviceAddress |
Category |
|
Interface |
Integer |
Access |
Read/Write |
Unit |
- |
Visibility |
Expert |
Values |
8 ... 118 |
Standard |
IDS |
Availability uEye+ |
|
Availability uEye |
|
|
Only addresses with a length of 7 bits are supported. |
|
Note for uEye cameras (UI models) The following addresses are reserved for uEye cameras and must not be used: : 0x10, 0x20, 0x21, 0x48, 0x49, 0x4C, 0x50, 0x51, 0x52, 0x55, 0x5C, 0x5D, 0x69 |
Code example
C++
// Determine the current I2CDeviceAddress
int64_t value = nodeMapRemoteDevice->FindNode<peak::core::nodes::IntegerNode>("I2CDeviceAddress")->Value();
// Set I2CDeviceAddress to 0x64
nodeMapRemoteDevice->FindNode<peak::core::nodes::IntegerNode>("I2CDeviceAddress")->SetValue(0x15);
C#
// Determine the current I2CDeviceAddress
long value = nodeMapRemoteDevice.FindNode<peak.core.nodes.IntegerNode>("I2CDeviceAddress").Value();
// Set I2CDeviceAddress to 0x64
nodeMapRemoteDevice.FindNode<peak.core.nodes.IntegerNode>("I2CDeviceAddress").SetValue(0x15);
Python
# Determine the current I2CDeviceAddress (int)
value = nodeMapRemoteDevice.FindNode("I2CDeviceAddress").Value()
# Set I2CDeviceAddress to 0x64 (int)
nodeMapRemoteDevice.FindNode("I2CDeviceAddress").SetValue(0x15)
