ATM60 - ATM60-P4H13X13 Sick Absolute Encoders - SICK Sensor - INOSAKI Automation Components Wholesales

ATM60 – ATM60-P4H13X13 Sick Absolute Encoders – SICK Sensor

$ 808.94

SKU: N/A

Model

Description

Incremental encoders generate information about position, angle, and rotation counts. The resolution is defined in the number of lines or pulses per rotation, which the encoder transmits to the control unit for each rotation. The current position can be determined by the control unit by counting these pulses. A reference run can be necessary when switching on the machine.

Part Number: 1030013
Encoders Model: ATM60-P4H13X13
OEM Spec Ref

Interfaces – Communication Interface detail: DPV0

Communication interface	PROFIBUS DP
Communication Interface detail	DPV0
Data protocol	Profile for encoders (07hex) – Class 2
Address setting	0 … 127, DIP switches or protocol
Data transmission rate (baud rate)	9.6 kBaud … 12 MBaud, automatic detection
Status information	LED green (operation), LED red ( bus activity)
Bus termination	DIP switch ¹⁾
Initialization time	1,250 ms ²⁾
Position forming time	0.25 ms
Set (electronic adjustment)	Via PRESET push button or protocol

¹⁾ Should only be connected in the final device.
²⁾ Valid positional data can be read once this time has elapsed.

Electrical data

Connection type	Connection adapter for PROFIBUS ¹⁾
Supply voltage	10 … 32 V
Power consumption	≤ 2 W (without load)
Reverse polarity protection	✔
MTTFd: mean time to dangerous failure	150 years (EN ISO 13849-1) ²⁾

¹⁾ Please order the bus adaptor seperately.
²⁾ This product is a standard product and does not constitute a safety component as defined in the Machinery Directive. Calculation based on nominal load of components, average ambient temperature 40°C, frequency of use 8760 h/a. All electronic failures are considered hazardous. For more information, see document no. 8015532.

Mechanical data

Mechanical design	Solid shaft, face mount flange
Shaft diameter	10 mm
Shaft length	19 mm
Weight	0.59 kg ¹⁾
Shaft material	Stainless steel
Flange material	Aluminum
Housing material	Aluminum die cast
Start up torque	2.5 Ncm, +20 °C, with shaft seal 0.5 Ncm, +20 °C, without shaft seal ²⁾
Operating torque	1.8 Ncm, +20 °C, with shaft seal 0.3 Ncm, +20 °C, without shaft seal ²⁾
Permissible Load capacity of shaft	300 N / radial 50 N / axial
Moment of inertia of the rotor	35 gcm²
Bearing lifetime	3.6 x 10⁹ revolutions
Angular acceleration	≤ 500,000 rad/s²