USD 26.51
Omron XS3F-M422-405-A is a 4-pole M8 right-angle socket with 5 m standard cable, IP67 protection, and 1 A DC, 125 VDC ratings.
The Omron XS3F-M422-405-A is a pre-wired M8 screw-on sensor connector with a 4-pole socket, right-angle cable exit and 5 m standard cable. Omron specifies 1 A DC, 125 VDC, IP67 protection and a four-core, 4 mm diameter cable, with an operating range of −25 to +70 °C. The manufacturer listed the exact model as selling and a standard-stock product on its latest status update dated 2026-08-27.
A 4-pole right-angle M8 socket with a 5 m cable for sensor I/O.
| Parameter | Value |
|---|---|
| Product type | Round water-resistant connector; socket on one cable end |
| Connector interface | M8 screw-on, 4 poles, socket |
| Connector orientation | Right-angle |
| Cable type | Standard cable |
| Cable construction | 4 cores; 4 mm outer diameter |
| Cable length | 5 m |
| Rated current | 1 A DC |
| Rated voltage | 125 VDC |
| Contact resistance | 40 mΩ max. (20 mV max., 100 mA max.) |
| Insulation resistance | 1,000 MΩ min. at 500 VDC |
| Dielectric strength | 1,000 VAC for 1 min.; leakage current 1 mA max. |
| Degree of protection | IP67 |
| Insertion durability | 200 insertions |
| Operating temperature | −25 to +70 °C |
| Operating humidity | 20–85% RH |
| Connector materials | Pin block: PBT; contacts: phosphor bronze, nickel base with gold plating; fixture: brass with nickel plating or SUS316L; O-ring: rubber; cover: soft PBT |
| Physical Weight (kg) | Not stated in the manufacturer data checked |
| Dimensions L x W x H (cm) | Refer to Omron's dimensional drawing for XS3F-M422-4[][]-A; no overall L × W × H value is stated in the product data. |
| Supply status | Active; Omron marked the exact item as selling and standard-stock on 2026-08-27 |
Engineering suggestions require suitability checks for your installation.
A compact machine layout may leave little straight clearance behind a sensor connector.
Use the right-angle socket to route the 5 m lead alongside the mounting surface, after checking mating compatibility, cable bend radius and clearance.
A sensor may need a longer pre-terminated connection to a nearby control or junction point.
Route the 5 m cable to a compatible input and observe the connector's 1 A DC and 125 VDC ratings; verify the assembled connection maintains the required IP67 protection.
